586-254-3444 or
586-726-9600 (massusie)
Assembly of nebulizing diffuser sets:
Optima (Professional) and Stellar (House)
You will see that there is tubing attached to the bottom of the glass piece. The open end of the tubing will attach to the air outlet on the pump. Hold the glass securely (carefully, too), and put the open end of
the tubing through the clip. You might have to wiggle or twist it a little.
Pull the tubing through until it stops, (which will be where the glass ends inside the tubing). The glass piece should rest on the clip. For hummingbirds: to put the oils in, carefully slide/pull the glass and tubing up and tilt the glass sideways, take out cork, add oil. Replace cork securely. Reposition the glass on pump above clip.
Hold the glass and press the open end of the tubing onto the pump's air outlet. 
Put oils in and plug it in!
- - - - - - - - - - - - - - - - -
To purify the air, nebulize for 15-30 minutes, 3-4 times a day.
For best results, use therapeutic grade oils, & do not add water unless you also want to vaporize also.
(Water weighs oil molecules down.)
- - - - - - - - - - - - - - - - - - - - - - -
The oil must cover over the open end of the little tube that takes the oils up, or it will not nebulize. Add more oil, check for a kink in the tube, or call or email me if it is not working!
notjustoils@wowway.com
586/254-3444
- - - - - - - - - - - - - - - - - - - - - - -
Using Prill Beads:
(1) wash off dust, etc. from the sack of Prill beads. 2) Fill a glass (NOT plastic or metal) gallon jar or container with common water. 3) Put Prill beads into it (with or without sack). It will sink to the bottom. 4) Allow it to sit for 24 hours. 5) You can pour off 3 quarts of water every hour - from this day on! Leave 1 quart of water behind to start your next batch. If a regular tap water source is used, this water will be greatly improved. Leave the lid off the jar so the chemicals can escape.
A great article by Dr. James A. Howenstine about Prill Beads: http://www.newswithviews.com/Howenstine/james54.htm
- - - - - - - - - - - - - - - - - - - - - - -
- - - - - - - - - - - - - - - - - - - - - - -
Assembling Wood Base Nebulizer:Put the glass piece into the rubber hole on the top, middle of the wood base. Press it in; secure it in place. Plug electric cord in on the base back side.
It take very little oil to start/keep this diffuser running. Press the switch to the left for high, to the right for low. It will shut itself off after an hour of staying on for one minute, then off for two minutes.
Take the round bulb off the top of the glass nebulizer. Add essential oils - from 3 to 15 drops. Replace bulb.
Oils will drip to the base.
Nebulization occurs as the air and the oils meet becoming lighter than air!
Do not put too much oil in or the pump will not survive long.
- - - - - - - - - - - - - - - - - - - - - - -
Hold glass firmly. Scrape tubing off of glass. Scrape off excess tubing.
Put the tubing over the glass. Twist and wiggle the tubing while holding the glass firmly with the other hand. Getting the glass a bit wet may help to slide it on. The tubing does not have to go all the way up, as long as tubing is secure.